Construction:
- GRP-sandwich construction for strength and insulation.
- Hull and deck completely joined by overlapping the GRP laminate. Bulwark formed in the deck and hull mouldings and fitted with a solid capping in teak.
- Handrails, companionway, hatchguides, sole and seats in cockpit are all in Bangkok-teak.
- Decks painted with non-skid
- Two 1 1/2" scuppers from the watertight and selfdraining cockpit.
- Ballast keel of iron, moulded in and completely protected in GRP.
- Rudder blade in GRP. Rudder main shaft Ø 40 mm bronze. Heavy cast rudder fittings in bronze.
Spars and rigging:
- Single spreader anodized aluminium alloy mast, deck stepped.
- Chainplates are made of stainless steel.
- Halyard winches: Two Lewmar 16ST, reef winch Lewmar 7C.
- Main boom 150/105 mm with a modern slab reefing system (2 reef Lines) + outhaul.
- Mainsail, triple stitched w/ (4) battens
- Storm Jib (never used)
- Mainsail Cover
- Binnacle cover
- Roller Furling Genoa, lightly used
- Harken RF
- SS Standing Rigging
- Genoa with sacrificial sun covers
- Boom Vang
- Whisker Pole mounted on Mast Track
- Lewmar 7 reefing winch
- (2) Lewmar 16 ST Halyard winch
- Lewmar 46's primary ST winches
Engine / Mechanical:
- Volvo MD 21B 4 cylinder FWC with instrumentation
- Two built in fuel tanks 150 + 90 l (tot. app. 63 US gallons) with separate pump for draining eventual water or sludge.
- Water tank 300 litres (app. 86 US gallon).
- The engine compartment is sound insulated for lowest possible noise level. The engine is accessible from the passageway for service. A bolted panel in the cockpit is detachable for lifting the engine.
- Pedestal steering, chain and sprocket system with stainless wire transmission to heavy quadrant. 30" stainless, elk hide covered steering wheel with adjustable friction brake.
- (1) Propane bottle w regulator,pressure gauge, and soelenoid switch/needs OPD device
- Optimus Propane stove 2 burner w Oven, gimbaled
- Double SS sinks in galley H/C pressure water
- SS Hot Water Heater AC or engine exchange
- Marine Air Systems Reverse Cycle Heat/Air w/ Elite Controls
- Dangles 12V-DC refrigeration
- Blue Seas 12volt DC Distribution panel (aftermarket )
- Paneltronicsx120Volt AC panel
- factory panel w circuit breakers
- VDO engine hour gauge 176
- VDO gauges for voltage, fuel and water tankage
- Espar Diesel Heater, out of boat for service
Electrical:
- 13 cabin lights and 2 fluorescent lights, one in galley and one in engine room. Central switch panel at navigation table with fuses and switches for the different circuits.
- Water and fuel gauge. Voltmeter and three 12 V outlets.
- Two main switches at the companionway ladder (one for the engine and one for the consumption).
- (2) 12volt house batteries
- (1) 12volt engine start batteries
- 30 Amp shore power
- Xantrex TC20+ 20amp tru-charge battery charger
- Guest Anchor Light
- 110 AC receptacles (non-GFI)
Accommodation:
- Satin finished Mahogany bulkheads, white overhead and Teak and Holly cabin soles.
- Water and gas tight locker for LPG bottles, anchor chain below. The space is accessible from deck and drained overboard.
- Forward cabin with two comfortable 6' 8" berths. Filler between berths. Stow room below berths. Cupboard forward in cabin above berths. Shelves at the sides.
- A door separates the forward cabin from the passage to the main cabin. On SB side of the passageway two good-sized hanging lockers.
- To port is head compartment with Wilcox Crittenden marine head, sink and cabinetry. Teak grating with sump compartment.
- Main cabin - settee/berths port and starboard with teak table and fold down leaves and storage inside. Book shelves and lockers behind settees.
- Aft in main cabin is a U-shaped galley equipped with a gimbled stove and ice box. Stainless double sink 24"x14" with manual fresh water pump. Surface of counter tops in galley in easy cleaned teak look plastic laminate. Locker for crockery. Waste basket, drawers, etc. fully equipped with plates, mugs,flatware, pots and pans and assorted cookery.
- To port is navigation table with chart locker, drawers, electric switch panel with voltage, fresh water and fuel tank meters. In the passageway to the aft cabin there is a work bench with stowage lockers.
- Locker for oil skin gear below companionway ladder.
- Drawers below berths in aft cabin. Cupboard above berths. Shelves at the sides. Hanging locker on port side of the cabin. Door to main cabin. Escape hatch to deck. Inside the hull is lined with mahogany.
- The upholstery in high quality furniture fabric with cushions in 4" heavy polyester foam.
- Four 12 V outlets in toilet cabin, galley, aft cabin and cockpit.
- The cockpit is selfdraining with seats and gratings in teak. Stow room accessible from cockpit.
- Stowage for winch handles etc.
- Anchor locker aft on deck.
Instruments / Electronics
- Icom VHF IC-M45
- Garmin Chart Plotter
- B&G Hornet Instruments (5)
- Garmin 4208 GPS Map on custom binnacle
- Sestral Compass binnacle mounted
- Autohelm 5000 v Autopilot
- Element TV w remote
- Bulkhead mounted Boston Clock and Barometer/kerosene lamp and thermometer
Gear/Additions to Standard:
- Electric windlass
- CQR 45lb w/chain rode
- Spare Anchor
- emergency tiller
- Docklines and Fenders
- Man overboard pole
- Dodger and Bimini
- Cockpit Enclosure
- Shade canvas with side curtains that covers the boat from the mast to the stern
- Painted Non-Skid decks (teak removed)
- Hull Sides, boot top, sheer stripe in Awlgrip
- Teak drink holder binnacle mounted
- Mahagony Cockpit table binnacle mounted
- Yachting ensign on teak flagstaff
- (2) Jim buoy Horseshoe type 4
- Outboard motor bracket
- (6) PFD's and (3) throwable type 4 cushions
- 30 amp shore power cord
- 50' utility hose
- 3 strand anchor rode w/ spliced thimble
- Boat scrub brush
- Gills Firth Radar Reflector
- Manual bilge pump Electric Bilge Pump
- Lewmar winch handle
- Spare dock lines
- Boat hook
Certificate
Each hull is built according to Lloyd's specifications for "Certificate of Hull Construction " and under personal supervision of Lloyd's surveyor in the respect of hull, deck and superstructures in GRP, main bulkheads, engine foundations, chainplates, rudder with fittings and built in fuel and water tanks.
Exclusions: owners personal effects including hand held compass, dividers, plotting equipment, plates, cups and glasses and all personal contents in cabinets and storage areas including binoculars.
Call for pricing
